Ordinance No. 20417 - Laserfiche WebLink

Home Browse Search

private street or alley shall be excluded. (b) Solar standards may impose a more restrictive lot standard. (See EC 9.2790 Solar Lot Standards.) (c) Lot area, frontage, and width minimums may be modified with an approved cluster subdivision in R-1 or Planned Unit Development (PUD) in any zone. (4) No variances to residential flag lot standards are allowed. Minimum lot area excludes the pole portion of the lot. Other residential flag lot standards also apply. (See EC 9.2775 Residential Flao Lot Standards for R-1. R-2. R-3 and R-4.) (9) Lot width and lot frontage minimums in R-2, R-3 and R-4 can be reduced to 20 feet as part of an approved site review plan, planned unit development, or cluster subdivision. Unless otherwise approved through a planned unit development or cluster subdivision, at no point, for the entire extent of the lot, shall the side lot lines be less than 20 feet apart. (10) Alley Access Only Lots/Parcels can be created only through an approved cluster subdivision in the R-1 zone or an approved planned unit development in any zone. Section 12. The caption for Section 9.2775 of the Eugene Code, 1971, is amended to provide as follows: 9.2775 Residential FlaQ Lot Standards for R-1. R-2. R-3 and R-4. Section 13. The paragraph preceding Table 9.3310 in Section 9.3310 of the Eugene Code, 1971, is amended to provide as follows: 9.3310 S-E Elmira Road Special Area Zone Land Use and Permit Reauirements. The following Table 9.3310 S-E Elmira Road Special Area Zone Uses and Permit Requirements identifies those uses in the S-E zone that are: (P) Permitted, subject to zone verification. (SR) Permitted, subject to an approved site review plan or an approved final planned unit development. Subject to an approved conditional use permit or an approved final planned unit development. Permitted, subject to an approved final planned unit development. Permitted subject to zone verification and the Special Development Standards for Certain Uses beginning at EC 9.5000. The numbers in ( ) in the table are uses that have special use limitations that are described in EC 9.3311. (C) (PUD) (S) (#) The examples listed in Table 9.3310 are for informational purposes and are not exclusive. Table 9.3310 does not indicate uses subject to Standards Review. Applicability of Standards Review procedures is set out at EC 9.8465. Ordinance - 9