Laserfiche WebLink
9,3823 <br /> <br />~ecial Standards for Table 9.3822. <br />(1) An adjustment may be made to the development standards of Table 9.3822 and <br /> this section in accordance with EC 9.8030(17). <br />(2) Rowhouse lots shall be indicated on the final plat and shall be developed with a <br /> rowhouse. Rowhouses are not required to comply with the density requirements <br /> fbr other types of residential development. <br />(3) Duplex lots shall be indicated or~ the final plat and shall be developed as a <br /> duplex. <br />(4) Tri-plex lots shall be indicated on the final plat and shall be developed as a tri~ <br /> plex. <br />(5) Four-plex lots shall be indicated on the final plat and shall be developed as a <br /> fbur-plex. <br />(6) Cul-de-sacs will only be permitted as provided in EC 9.6815 and EC 9.6820. <br />(7) Cul-de-sacs are not permitted in areas designated for Medium-Density <br /> residential use. <br />(8) Duplex division lots shall comply with other duplex division provisions. (See <br /> EC 9.2777 Duplex Division Lot Standards.) <br /> <br />Section 3. Section 9.8030 of the Eugene Code, 1971, is amended by adding a new <br /> <br />Subsection (17') thereto, to provide as follows: <br /> <br />9.8031} Adjn~t.~ent Re¥iew r ApprOval Criteria. The planning director shall approve, <br /> conditionally approve, or deny an adjustment review- application. Approval or <br /> conditional approval shall be based on compliance with the following applicable <br /> criteria. <br /> <br />(17) S-RN Royal Node Special Area Zone Standards Adjustments A standard <br /> applicable within the S-RN Royal Node Subarea LDR, MDR, RMU, CMU or <br /> MSC may be adjusted upon a finding that the proposed adjustment: <br /> (a) Is consistent with the proposes of the S-RN Royal Node Special Area <br /> Zone as set fbrth at EC 9.3800; and <br /> (b) Meets the applicable adjustmem criteria in another subsection of EC <br /> 9.8030, if any. <br /> If there is no EC 9. 8030 subsection that pertains to the type of standard being <br /> considered, adjustment may be permitted based solely on compliance with EC <br /> 9~8030(I7)(a). <br /> <br />Section. 4. Section 9.8865 of the Eugene Code, 1971, is amended by adding in numerical <br /> <br />order by Code provision, a new Subparagraph to Subsection (4), and relettering the subparagraphs <br /> <br />that follow, to provide: <br /> <br />Ordinance - 22 <br /> <br /> <br />