Laserfiche WebLink
Section 7. The following entries under the "Maximum Building Height," "Minimum Building <br />Setbacks," "Maximum Lot Coverage" and "Secondary Dwellings" sections in Table 9.2750 of the <br />Eugene Code, 1971, are amended to provide as follows: <br />Table 9.2750 Residential Zone Development Standards <br />See EC 9.2751 Special Develo ment Standards for Table 9.2750. <br />R-1 R-1.5 R-2 R-3 R-4 <br />17 ,18 <br />Maximum Building Hei ht 2 , 3 , 4, 5 , 16 ,(17)10§ <br />AccessoryDwellingSee 17 —See 17 —See 17 —See 17 <br />Minimum Building Setbacks 2 4 6 9 10 11 16 17 18 <br />Interior Yard Setback for <br />Accessory Dwellings <br />See (17) <br />—See (17) <br />—See <br />Maximum Lot Coverage (17), 18 <br />Lots with Accessory Dwellings <br />(Area -Specific) <br />See <br />17 c <br />Accessory Dwellings 17 <br />General Standards <br />See <br />(17)(a) <br />and b <br />—See <br />(17)(a) <br />and b <br />—See <br />(17)(a) <br />and b <br />—See <br />(17)(a) <br />and b <br />Area -Specific <br />See <br />(17)(c) <br />Section 8. Figure 9.2751(17)(a)3.b.(2)(A), Figure 9.2751(17)(a)3.b.(2)(B), and Figure <br />9.2751(17)(a)3.c.(2) attached to this Ordinance as Exhibit Aare added, and Subsection (17) of <br />Section 9.2751 of the Eugene Code, 1971, is amended to provide as follows: <br />9.2751 Special Development Standards for Table 9.2750 <br />(17) Accessory Dwellings. <br />(a) General Standards for Attached Accessory Dwellings. Except as <br />provided in subsection (c) below, accessory dwellings that are within the <br />same building as the primary dwelling shall comply with all of the <br />following: <br />1. Lot Area. To allow an accessory dwelling, flag lots shall contain at <br />least 12,500 square feet, excluding the pole portion of the lot, and <br />shall have a minimum pole width as required under EC <br />9.2775(5)(e). All other lots shall contain at least 6,100 square <br />feet. <br />2. Building Size. The total building square footage of an accessory <br />dwelling shall not exceed 10 percent of the total lot area or 800 <br />square feet, whichever is smaller. Total building square footage is <br />measured at the exterior perimeter walls and is defined as all <br />square footage inside of the dwelling, including, but not limited to <br />hallways, entries, closets, utility rooms, stairways and bathrooms. <br />3. Building Height/Interior Setback. Except for accessory dwellings <br />on flag lots (see EC 9.2775), the following standards apply: <br />a. For any portion of an attached accessory dwelling located <br />Ordinance - Page 3 of 17 <br />