Laserfiche WebLink
standards are allowed where the affected adjacent property <br />owners consent in writing on a form approved by the city. <br />4.Adjustments. The standards at EC 9.2775(5)(e)2.b. and d. <br />regarding driveway setbacks and landscaping may be adjusted in <br />accordance with EC 9.8030(34)(b). <br />Section 10. Subsections (2)(a) and (3)(a) of Section 9.3065 of the Eugene Code, 1971, <br />are amended and (3)(k) is added to provide as follows: <br />9.3065 S-C Chambers Special Area Zone – Development Standards. <br />(2)Development Standards Applicable in the S-C/R-1 Subarea.Except as <br />provided in this subsection, the development standards applicable in the S- <br />C/R-1 Subarea shall be those set forth in EC 9.2750 to EC 9.2777 for the R-1 <br />zone, Special Development Standards for Certain Uses in EC 9.5000 through <br />EC 9.5850, and the General Standards for all Development in EC 9.6000 <br />through 9.6885. <br />(a) Lot Size Minimums for Flag Lots. In lieu of any conflicting provisions in <br />EC 9.2750 to 9.2777 for flag lots in the R-1 zone, the following standards <br />apply for flag lots in the S-C/R-1 subarea: <br />1. Single dwellings: minimum lot size 4,500 square feet. <br />2. The original lot, prior to creation of the flag lot, is not subject to a <br />minimum lot size of 13,500 square feet. <br />In calculating the lot area, only the flag portion of the lot (exclusive of the <br />pole) is counted. <br />* * * <br />(3) Development Standards Applicable in S-C/R-2 Subarea. Except as <br />provided in this subsection, the development standards applicable in the S- <br />C/R-2 subarea shall be those set out in EC 9.2750 to 9.2777 for the R-2 zone, <br />Special Development Standards for Certain Uses in EC 9.5000 through EC <br />9.5850, and the General Standards for all Development in EC 9.6000 through <br />9.6885. <br />(a) Density Standards. In lieu of the density standards for the R-2 zone in <br />Table 9.2750 and EC 9.2750(1), there is no minimum density <br />requirement regardless of lot size, and the following maximum density <br />standards apply: <br />1. For lots with street access: <br />a. If the lot area is less than or equal to 4500 square feet: One <br />dwelling unit and, if the dwelling is a detached one-family <br />dwelling, one accessory dwelling. <br />b. If the lot area is greater than 4,500 square feet and less than <br />or equal to 9,200 square feet: Two dwelling units and one <br />accessory dwelling for each detached one-family dwelling. <br />c. If the lot area is greater than 9,200 square feet: Three <br />dwelling units and one accessory dwelling for each detached <br />one-family dwelling. <br />2. For an alley access lot of any size: One dwelling unit and, if the <br />dwelling is a detached one-family dwelling, one accessory <br />dwelling. <br />* * * <br />Ordinance - Page 13 of 25 <br /> <br /> <br />