Ordinance No. 19771 - Laserfiche WebLink

Home Browse Search

which reduce heat loss to levels equivalent to the perf~rm- ance standards required of single-family dwellings c~nstruct- ed under the State Bui 1 di ng Code. 8. Foundation: The hame shall be placed on an excavated and back-filled foundati an and encl ased at the perimeter such that the home is located nOt more than 12 inches above grade. The home and accessory building faundati ons and structures must be of sufficient strength to support the required live- loads and actual dead-loads imposed by the home and any attached or supported structure based on accepted engineering standards. ~ b} The manufactured hame must possess an insignia shawl ng that it was manufactured according to the National Manufactured Housing Construction and Safety Standards Code. ~c} The siting of the manufactured home shall comply with all applicable provisions of sections 9.802 to 9.820 of this code. ~ 23 } Manufactured Dwel 1 i ng Parks : ~a} Must meet the following standards: 1. Minimum area: Three acres. 2. Maximum density: Ten spaces per acre, 3. Perimeter treatment. Except as required far vi s i an clearance, the outer perimeter of each park shall be improved with a. Asite-obscuring fence or wall not less than five nor more than six feet i n height; and b. Maintained evergreen landscaping that is at least ten feet in depth, will mature within three years, and wi 11 reach at 1 east five feet i n height at maturity. 4, Occupied area surface treatment. Unless in canfl ict with state 1 aws and regulations, al 1 areas covered by manu- factured dwel 1 i ngs and accessary bui 1 di ngs shall be paved with asphalt or concrete, or covered with permanently con- tained crushed rock. 5. Accessory bui 1 di ngs and structures setbacks . Car- ports, storage buildings, awning~s~~~~~and~ patio covers and their supportive structures, porches, accessory buildings, and structures aver 30 inches in height shall be located at least six feet from the abutting lots' manufactured dwellings, accessory buildings, and structures. 6. Manufactured dwel 1 i n and accessor bui 1 di n su ort and ti e~-down. Manufactured dwelling and accessory bui 1 di ng foundations shall be of sufficient strength to support the required live-loads and actual dead-loads imposed by the manu- factured dwelling and any attached or supported structure based on accepted engineering design standards. Foundations, ti e-downs, or other supports shal 1 be provided to withstand the specified horizontal , up-1 i ft, and overturning wind forces on the dwell i ng and any attached or supported structures based on accepted engineering design standards . 7. Recreational vehicle use. Conform to the require- ments of Section 9.808 of this code, 8, Solar access. Conform to the requirements of sec- tion 9.S~o of this code. ordinance - 8