Ordinance No. 20355 - Laserfiche WebLink

Home Browse Search

(h) Lot Standards. In lieu of conflicting lot standards for the R-2 zone in Table 9.2760 and EC 9.2761 Special Standards for Table 9.2760, the following minimum standards apply to all new lots created after December 12,2005 or requests for property line adjustments to existing lots that are submitted after that date: 1. Minimum lot frontage: 45 feet. For alley access lots, lot frontage is that portion abutting the alley. 2. Minimum lot width on street or alley: 45 feet. 3. Minimum lot depth (interior yard): 45 feet. 4. Maximum lot size: 13,500 square feet. 5. Alley access lots are permitted, subject to the development standards of this section. 6. Flag lots are not permitted. 7. The following special limitations shall apply: a. Lot Aggregation: 2 or more lots or parcels shall not be combined or reconfigured such that the resulting number of lots or parcels is reduced. This requirement includes, but is not limited to partition or subdivision replats and property line adjustments. b. Property line adjustments: Property lines may be adjusted up to 5 feet, measured perpendicularly from the existing property line, provided that all other provisions of this section and EC 9.8400 through EC 9.8420, Property Line Adjustments, have been met. (i) Adiacent Lot Development. Developments that span 2 or more adjacent lots must meet standards for each individual lot (e.g. density, setbacks, etc.). U) Vehicle Use Area. The total vehicle use area shall not exceed 20 percent of the lot size. (4) Development Standards Applicable in the S-C/C-2 Subarea. Except as provided in this subsection, the development standards applicable in the S- C/C-2 subarea shall be those set forth in EC 9.2170 to 9.2181 for the C-2 zone, Special Development Standards for Certain Uses in EC 9.5000 through EC 9.5850, and the General Standards for all Development in EC 9.6000 through 9.6995. (a) Street Facades. Ground floor facades that are 15 feet or closer to the front property line shall have windows, arcades, colonnades, display windows, entry areas, awnings, canopies or other similar features along no less than 50% of their horizontal length. (b) Heiaht Limitation. No portion of a building located within 50 feet of a residential zone shall exceed the maximum height in that residential zone's or overlay zone's accessory building height limit. Section 4. A new Subsection (23) is added to Section 9.8030 of the Eugene Code, 1971, to provide: 9.8030 Adiustment Review - Approval Criteria. The planning director shall approve, conditionally approve, or deny an adjustment review application. Approval or Ordinance - 8