Laserfiche WebLink
(a) Types. The type of fence (including walls or screens) used is <br />subject to specific requirements stated in the landscape standards <br />beginning at EC 9.6200 Purpose of Landscape Standards. The <br />standards apply to walls, fences, and screens of all types including <br />open, solid, wood, metal, wire, masonry or other material. Use of <br />barbed wire and electric fencing is regulated in EC 6.010(d) Fences. <br />(b) Location and Heights. <br />1. Fences up to 42 inches in height are permitted within the <br />required front yard setback. For corner lots or double <br />frontage lots, a fence between 42 inches and 6 feet in height <br />is permitted within one of the two front yard setbacks, so <br />long as for corner lots, this fence cannot extend past a line <br />created by an extension of the front wall of the dwelling. (See <br />Figure 9.2751(13)(b)1.) <br />2. Fences up to 6 feet in height are permitted within the required <br />interior yard setback. <br />3. The height of fences that are not located within the required <br />setback areas is the same as the regular height limits of the <br />zone. <br />4. Fences must meet the standards in EC 9.6780 Vision <br />Clearance Area. <br />(9) Maximum building height and minimum building setbacks may be <br />modified with an approved planned unit development permit. (For <br />planned unit development procedures refer to EC 9.7300 General <br />Overview of Type III Application Procedures and for approval criteria <br />refer to EC 9.8320 Tentative Planned Unit Development Approval Criteria <br />- General. <br /> <br />9.3630 S-JW Jefferson Westside Special Area Zone Lot Standards. The following <br />Table 9.3630 sets forth S-JW Jefferson Westside Special Area Zone lot <br />standards, subject to the special standards in EC 9.3631. <br /> <br /> <br />Table 9.3630 S-JW Jefferson Westside Special Area Zone Lot Standards <br />(See EC 9.3631 Special Standards for Table 9.3630.) <br /> <br />Lot Area Minimum (1) <br />Lots, except Small Lots, Alley Access Only Lots 4,500 square feet <br />Small Lots (2) 2,250 square feet or per Cluster <br />Subdivision or PUD <br />Alley Access Only Lots (4) 2,250 square feet <br />Frontage Minimum (1) <br />Interior Lot 45 feet <br />Corner Lot 45 feet <br />Lot Area Maximum (3) 13,500 square feet <br /> <br />9.3631 Special Standards for Table 9.3630. <br />(1) (a) Lot frontage requirements may be met by a lot that abuts a street <br />or an alley continuously for the required length indicated in Table <br />9.3630. <br />(b) A lot must be of sufficient size and/or have sufficient on-street <br />parking to meet applicable vehicle parking requirements under EC <br />9.3625(3)(b)4 or EC 9.3625(7) for one dwelling, or all existing <br />Ñ®¼·²¿²½» ó п¹» ïë ±º îï <br />