Ordinance No. 20449 - Laserfiche WebLink

Home Browse Search

Table 9.3630 S-JW Jefferson Westside Special Area Zone Lot Standards (See EC 9.3631 Special Standards for Table 9.3630.) Lots, exceptSmall Lots, Alley Access Only Lots 4,500 square feet Small Lots(2)2,250 square feet or per Cluster Subdivision or PUD Alley Access Only Lots (4) 2,250 square feet Frontage Minimum (1) Interior Lot 45 feet Corner Lot 45 feet Lot Area Maximum (3)13,500 square feet 9.3631 Special Standards for Table 9.3630. (1) (a) Lot frontage requirements may be met by a lot that abuts a street or an alley continuously for the required length indicated in Table 9.3630. (b) A lot must be of sufficient size and/or have sufficient on-street parking to meet applicable vehicle parking requirements under EC 9.3625(3)(b)4 or EC 9.3625(7) for one dwelling, or all existing dwellings on the lot at the time the lot is created, whichever is greater. (c) Rectilinear shape. A lot line segment is a portion of the boundary line of a lot that is bounded on each end by an angle and that contains no angles within the line segment. (The point at which a straight line intersects a curved line is considered an angle.) 1. All lot line segments must be straight lines and intersect at right angles (90 degrees). 2. Exceptions a. Lot line segments may intersect at an angle between 85 and 95 degrees to the extent that will produce a lot with at least four sides and a lot boundary with fewer angles than could be accomplished using only right angles. b. An angle between 45 and 135 degrees is allowed where a new lot line intersects a lot line segment that existed prior to December 14, 2009, and the existing lot line segment did not intersect both its adjoining lot line segments at right angles. (d) A lot’s boundaries must be sufficient to fully encompass a rectangle of the following size: 1. Alley access only lots: 45’x35’ 2. Other lots: 45’x45’ (See Figure 9.3631(1)(d)(e)) . (See Figure 9.3631(1)(d)(e)) (e) Minimum interior lot dimension. . The minimum distance between any two non-intersecting lot line segments is 35 feet when measured by a straight line that does not begin or end at an intersection of any two lot line segments and that lies entirely within the lot's boundaries. (f) The Property Line Adjustment provisions at EC 9.8400 through 9.8420 are available within the S-JW zone only for adjustment of a portion of a lot line that existed in its current location as of December 14, 2009. Such lot lines may be adjusted by up to 5 feet, measured perpendicularly from the lot line’s current location, and consistent with all other applicable lot standards. A Property Line Adjustment allowed Ordinance - Page 15 of 19