Laserfiche WebLink
~f} Lot and Parcel Side Lines. As far as is practicable, <br />lot and parse s~ e ~ nes sha i run at right angles to the street <br />upan which the lots or Parcei s face, except that on curved streets <br />they shat 1 be radi ai to the curve. <br />~ g} Sui tabi i i ty for Intended Use. Ail lots and Parcei s <br />shat l be sup tabl e for the purpose for which they are intended to <br />be used. No lot or parcel shall be of such size or design as to <br />be detrimental to the health, safety or sanitary needs of the <br />residents of the subdivision or partition, or of such lot or par- <br />cel, as determined by the planning director in accordance with the <br />purpose in section 9.010 of this Code. <br />~h} Future Subdivision or Partition of Lots or Parcei s. <br />[here the subdivision or partition will result i n a l of or parcel <br />one-hal f acre or 1 anger i n size which i n the judgment of the pl an- <br />i ng director i s 1 i kel y to be further divided i n the future, the <br />planning director may require that the location of lot and Parcei <br />i i nes and other details of 1 ayout be such that future division may <br />readily be made without violating the requirements of this Code <br />and without interfering with orderly extension of adjacent streets. <br />Any restriction of buildings within future street locations shat 1 <br />be made a matter of record if the planning director deems it <br />necessary for the purpose of future sand division. <br />~i} Solar Design Standards. <br />1. Applicability. The Solar Design Standards set out <br />i n this subsect~ on apply on] y to land located i n the RA, R-1, <br />R-2, R-3, and C-~1 zoning Districts, The subdivision or parti - <br />ti on must be designed so that at least 80 percent of the total <br />number of platted or mapped lots will be protected under the <br />soi ar access provisions of this code or be exempt lots as de- <br />fined below. These cots are solar access protected lots and <br />must be identified as such on the f i na i plat or map. <br />z. Solar design standards alternatives. Al 7 plats and <br />maps shall conform to either of the following Solar Design <br />Standards: <br />Prescriptive approach, Each lot to the south of a <br />solar access protected lot must be designed to have a <br />minimum solar factor north-south dimension corrected for <br />slope} as follows: <br />zone Solar Factor din feet} <br />RA, R-1, C-1 75 <br />R-2, R-~3 64 <br />Other zones Not appl i cabl e <br />(See Table 1.) <br />Performance approach. The land divider may use an <br />alternative p atting or mapping method that ensures a <br />level of solar access protection far the solar access <br />protected lots equal to that provided by restrictions i m- <br />posed under the Solar Setback Standards in section 9.535, <br />Solar setback requirements for each lot must be recorded <br />directly an the final plat or map in the manner prescrib- <br />ed by the city manager. <br />Ordinance w 11 <br />