Ordinance No. 20528 - Laserfiche WebLink

Home Browse Search

(S)Permitted subject to zone verification and the Special Development Standards for Certain Uses beginning at EC 9.5000. (#)The numbers in ( ) in the table are uses that have special use limitations that are described in EC 9.3911. Examples of uses in Table 9.3910 are for informational purposes and not exclusive. Table 9.3910 does not include uses subject to Standards Review. Applicability of Standards Review procedures is set out at EC 9.8465. Table 9.3910 S-W Whiteaker Special Area Zone Uses and Permit Requirements S-W Accessory Uses Accessory Uses. Examplesrelated to residential uses include a garage, storage P shed, bed and breakfast facility (see EC 9.5100), home occupations (see EC 9.5350), and secondary dwellings (see EC 9.2741(2)). Examplesrelating to commercial and employment andindustrial uses include security work, administration activity and sales related to industrial uses manufactured on the same development site, and storage and distribution incidental to the primary use of the site. Manufacturing Paper and Allied ProductsP Section 36. Subsection (10) of Section 9.3915of the Eugene Code, 1971, is amended to provide as follows: 9.3915S-W Whiteaker Special Area Zone Development and Lot Standards. Except as provided in subsections (5) to (12) of this section, sections 9.6000 to 9.6885 General Standards for All Development in this land use code shall apply within this S-W zone. In the event of a conflict between the general development standards of this land use code and the standards set forth in this section, the specific provisions of this section shall control. (10)Sign Standards. The provisions of the Employment andIndustrial Sign Standards set forth in this land use code shall apply within this S-W zone, except that additional restrictions may be imposed through site review. Section 37. Subsection (1)(c) of Section 9.4290of the Eugene Code, 1971, is amended to provide as follows: 9.4290Density and Development Standards. In addition to the requirements of the base zone, the following standards shall applyto all development, except that the standards in subsection (2) and (3) do not apply to single-family dwellings or duplexes: (1)Minimum Residential Density and Floor Area Ratio (FAR). (a)Where the base zone is R-1 or R-1.5, new subdivisions shall achieve a minimum residential density of 8 units per net acre. Minimum residential density in R-2 shall be 15 units per net acre; in R-3 it shall be 25 units per net acre; and in R-4 it shall be 30 units per net acre. Ordinance -Page 30of 48