Admin Order 53-17-01-F - Laserfiche WebLink

Home Browse Search

7.3.1. The special inspector shall observe the work assigned for conformance with the approved design drawings and specifications. 7.3.2. The special inspector shall furnish inspection reports to the Building Official, the engineer or architect of record, and other designated persons. All discrepancies shall be brought to the immediate attention of the contractor for correction, then, if uncorrected, to the proper design authority and to the Building Official. 7.3.3. The special inspector shall submit a final signed report stating whether the work requiring special inspection was, to the best of the inspector's knowledge, in conformance with the approved plans and specifications and the applicable workmanship provisions of these regulations and applicable codes. 7.4 Waiver of Special Inspection. The Building Official may waive the requirement for the employment of a special inspector if the construction is of a minor nature. 7.5 Periodic Special Inspection. Some inspections may be made on a periodic basis and satisfy the requirements of continuous inspection, provided this periodic scheduled inspection is performed as outlined in the project plans and specifications and approved by the Building Official. 7.6 Approved Fabricators. Special inspections required by this section and elsewhere in these regulations, the administrative code or the technical codes shall not be required where the work is done on the premises of a fabricator registered and approved by the Building Official to perform such work without inspection. The certificate of registration shall be subject to revocation by the Building Official if it is found that any work done pursuant to the approval is in violation of the codes. The approved fabricator shall submit a Certificate of Compliance that the work was performed in accordance with the approved plans and specifications to the building official and to the engineer or architect of record. The approved fabricator's qualifications shall be contingent on compliance with the following: 7.6.1. The fabricator has developed and submitted a detailed fabrication procedural manual reflecting key quality control procedures which will provide a basis for inspection control of workmanship and the fabrication plant. 7.6.2. Verification of the fabricator's quality control capabilities, plant and personnel as outlined in the fabrication procedural manual shall be by an approved inspection or quality control agency. 7.6.3. Periodic plant inspections shall be conducted by an approved inspection or quality control agency to monitor the. effectiveness of the quality control program. Administrative Order - Page 28 of 40